three stars in series - Printable Version +- Syncrolight Forum (https://www.syncrolight.co.uk/forum) +-- Forum: Light Shows (https://www.syncrolight.co.uk/forum/forumdisplay.php?fid=1) +--- Forum: General (https://www.syncrolight.co.uk/forum/forumdisplay.php?fid=2) +--- Thread: three stars in series (/showthread.php?tid=225) |
three stars in series - sheepdip - 21-09-2021 Hi, I've have made three stars of 40 pixels each and wired them in series to the same output on the controller. My question is this. Can I control each one as a separate item using the same controller output but call each by a separate name? Am I asking too much? Any and all help would be great! RE: three stars in series - Craig - 21-09-2021 What Controller do you have ? If you have the ETH-08 Pixel controller, you can use the Device manager and create a virtual output on the controller that is mapped to the relevant pixels (i.e. Output 10 => Maps to Output 2 pixels 50 to 100). If you have the SL-4000 or SL-8000 let me know and I will look for another solution as I don't think virtual outputs were implemented on those. Craig. RE: three stars in series - sheepdip - 21-09-2021 (21-09-2021, 05:00 PM)Craig Wrote: What Controller do you have ? Thank you, I'll give that a go tomorrow and let you know how I get on. I DO have an ETH08 so it should all be good. RE: three stars in series - sheepdip - 22-09-2021 Thanks Craig, all sorted. Have posted a review on trustpilot as a thank you for your brilliant support. Alec Sheppard |