15-12-2020, 02:42 PM
(This post was last modified: 15-12-2020, 02:43 PM by Doodley.
Edit Reason: Typo
)
Hi all,
I'm new to syncrolight and I must say I'm really impressed with their service and support.
I wonder if anyone may be able to help me with a network connection please. I have a Sl-8000 pixel control which I have set up and controlling pixels in slave mode. I want to connect my other RS485 controller's to this by the rs485 output on the SL-8000 and keep using it as a slave control, but I can't seem to figure out how to configure the ethernet network so that the other Rs485 controllers run from the SL-8000.
Any pointers would be greatly appreciated.
Thank you.
I'm new to syncrolight and I must say I'm really impressed with their service and support.
I wonder if anyone may be able to help me with a network connection please. I have a Sl-8000 pixel control which I have set up and controlling pixels in slave mode. I want to connect my other RS485 controller's to this by the rs485 output on the SL-8000 and keep using it as a slave control, but I can't seem to figure out how to configure the ethernet network so that the other Rs485 controllers run from the SL-8000.
Any pointers would be greatly appreciated.
Thank you.