13-01-2022, 07:12 PM
Hi
First thing is that you should have really started a new Thread, instead of tagging onto this one. What could happen is that the thead gets so far deviated from it's original subject.
If you are cutting your LED strings (which are NOT Pixels!!!!!) and want to try them with a power supply, then 100 LEDs take approximately 250mA (so a 24v DC supply rated at 1Amp would be sufficient. Don't test your lights using the 24v Transformer and ac/dc converter (that will burn them out)
If you start a new Thread, then I will go into more details, although these have been explained in previous threads.
Hope that little bit helps
Regards
Sandy
First thing is that you should have really started a new Thread, instead of tagging onto this one. What could happen is that the thead gets so far deviated from it's original subject.
If you are cutting your LED strings (which are NOT Pixels!!!!!) and want to try them with a power supply, then 100 LEDs take approximately 250mA (so a 24v DC supply rated at 1Amp would be sufficient. Don't test your lights using the 24v Transformer and ac/dc converter (that will burn them out)
If you start a new Thread, then I will go into more details, although these have been explained in previous threads.
Hope that little bit helps
Regards
Sandy